Maytag MHP1000SQ - Manuel (Page 4)

INSTALLING THE PEDESTAL
Follow these instructions to install the pedestal on a washer
or dryer.
Make sure that all four spacer pads are in place on the top of
the pedestal. These pads reduce vibration between the pedestal
and the washer/dryer.
note:
If your washer/dryer has feet installed, remove them.
Do not install the feet that came with a new washer/dryer.
Partially install two of the #12 x 5/8" hex head sheet metal
screws in the lower holes. Leave a space of about 3/8" (10 mm)
between the screw head and the bottom of the washer/dryer.
Move the pedestal against the washer/dryer bottom. Slide the
pedestal’s keyhole slots over the lower two partially installed
screws.
Position the pedestal toward the front of the washer/dryer and
install the two remaining hex head sheet metal screws. Do not
tighten completely.
Align the sides of the pedestal so that they are even with the
sides of the washer/dryer. Reach inside the pedestal opening
and securely tighten all four pedestal screws.
4
WARNING
Excessive Weight Hazard
Use two or more people to move and install pedestal.
Failure to do so can result in back or other injury.
1.
locate spacer pads
2.
Prepare the washer/dryer
3.
attach the pedestal
4.
secure the pedestal
Dryer Bottom Washer Bottom
5.
align sides of pedestal