Hoover S3825 - Manuel (Page 14)

step III
If belt is not broken
but is stretched or
cut, pull it off the
motor pulley (D).
Lift up end of
agitator brush roll.
Remove old belt
from agitator pul­
ley (E) and replace
with new belt.
Lettering on belt
must be visible.
Stretch belt back
and attach to motor
pulley.
step IV
Hold opposite end
of agitator brush
roll in place. Push
belt end forward,
rotating end plate
(F) until it slides
into place. Turn
agitator, mak­
ing sure it rotates
freely.
Step V
Position hood on
top of nozzle base.
Turn nozzle over.
Replace the 7
Philips head screws.
Agitator brush roll replacement
When to replace
Disconnect cleaner
from electrical outlet.
When agitator brush
roll brushes are worn,
the brush roll should
be replaced.
To check condition of
brushes, move edge of
a card across bottom
plate while turning brush roll. To maintain
cleaning effectiveness, replace brush roll if
brushes do not touch card.
What to buy
When purchasing a new agitator brush roll,
ask for HOOVER part no. 59135316.
How to replace
Disconnect cleaner from electrical outlet.
1. Remove hood, belt and brush roll as
shown in Figs. 2.9 to 2.11.
2. Discard old brush roll.
3. Replace new brush roll and belt as shown
in Figs. 2.12 and 2.13.
Headlight replacement
The headlight, located on top of the power nozzle, operates when
the cleaner is turned on. Use only HOOVER part no.
59135317,
when replacing the headlight.
How to replace
Disconnect cleaner from electrical outlet and disconnect power
nozzle from extension wand.
1. Remove the hood as shown in Fig. 2.10.
2. Pull old bulb from socket. Push new bulb into socket.
3. Replace hood.
14