Hoover S3825 - Manuel (Page 13)

Cleaning the Exhaust Filter
NOTE:This is located on the rear of the vacuum cleaner.
2 . 8
. ■ - - 1
— i ■ )
f 'L
, r ^
;Vj
i
1
(
i
V
■
-----
Step I
Release the exhaust
filter cover and
remove the cover as
shown. Remove the
filter by pulling the
tab towards you.
Step II
Tap the pleated
filter on the inside
of a trash can to
remove excess dust
and dirt.
WARNING: Do not
apply water to
pleated filter.
NOTE: Replace
filter if any sign of
damage.
Step III
Once cleaned
return the exhaust
filter to the
vacuum cleaner.
Replace the exhaust
filter cover before
restarting the vacu­
um cleaner.
What to buy
When purchasing a
new HEPA Exhaust
Eilter, ask for
HOOVER part no.
AH40010.
Power Nozzle belt replacement
The belt in your power nozzle drives the
agitator. It has been designed specifically
for use in this cleaner and is important for
effective operation.
What to buy
There are other belts manufactured that
are similar in shape and size, but are not
designed for the HOOVER power nozzle.
Such belts do not operate the agitator cor­
rectly and may create stress which could
damage your power nozzle. Use only a
genuine HOOVER Belt part no.
AH20000
when a belt replacement is necessary.
When to replace
The belt should be checked from time to
time to be sure it is in good condition. To
check, remove the hood (see following sec­
tion). Replace the belt if it is stretched, cut,
or broken.
How to replace
Step I
Disconnect cleaner
from electrical
outlet and discon­
nect power nozzle
from extension
wand.
To remove hood,
turn nozzle over
and unscrew the
7 recessed Phillips
head screws.
Step II
Return nozzle
to original posi­
tion. Lower Quick
Disconnect by
depressing down
the handle release
pedal and lift off
the hood.
13