Hoover S3825 - Manuel (Page 12)

Cleaning the Cyclone Separator
step I
Twist lid to the
unlock position and
pull the dirt con­
tainer bin off the
cyclonic separator.
Step II
The separator
should be cleaned
with a soft brush
and wiped with a
damp cloth. The
dirt container bin
may be wiped to
clean.
step III
Leave the separator
to dry completely
before replacing.
IMPORTANT: The
cyclonic separator
should not be sub­
merged in water
Step IV
Replace the dirt
container as direct­
ed, by twisting lid
to the locked pos­
tion.
Cleaning the Pre-Motor Filter
NOTE: This is located underneath the dirt container bin.
step I
Release the pre­
motor filter cover
by lifting up the
tab. Lift off the
filter cover to gain
access to the filter.
Remove the filter
by pulling the tab
towards you.
Separate the foam
filter from the fab­
ric cassette. Each
filter can be tapped
against the side
of a trash can to
remove the excess
dirt and dust.
step III
The pre-motor
filter may be
rinsed in warm
water. Allow to air
dry for 24 hours
before replacing.
NOTE: Do not use
any detergents or
boiling water to
wash the filters.
For best perfor­
mance, the foam
filter should be
cleaned each time
the dirt container is
emptied.
step IV
Once completely
dry, return the
pre-motor filter
and cassette to the
vacuum cleaner.
Replace the pre­
motor filter cover
before restarting
the vacuum cleaner.
12