Levana Jena V1 Manual - Manuel (Page 19)

Note: If “C1...X” appears (pairing failed) you will have to disconnect the power
supplies from the camera and monitor and start the pairing process again.
Light
Sensor
The camera and monitor come paired (connected) to each other automatically.
However, if upon opening this package the devices do not automatically connect and
transmit, you may have to do so manually. Any additional cameras you purchase will
need to be paired manually.
1. Slide the POWER switch on the right side
of the camera to the OFF position.
2. Place a thick cloth or your hand tightly over the
light sensor on the camera, preventing any light
from reaching the sensor. NOTE: Keep the light
sensor covered during the entire
pairing process.
3. With the light sensor covered, slide the POWER
button
on the camera to the ON position.
4. While the monitor is ON, press and hold the
PLAY/PAUSE button
on the left side of the
monitor for two seconds.
5. The pairing icon
1, 2, 3 or 4
will appear on the screen
(depending on the number of cameras you are pairing) and the POWER LED on
the camera you are currently pairing will blink for a few seconds.
6. To switch to a different camera view, press the MENU button until you see
the current camera icon. Use the buttons on the left side of the monitor to
switch to a different camera.
7. Press the MENU button on the monitor to confirm the setting.
8. C1... OK! will appear when the camera and monitor are paired successfully and
then the video and audio will be transmitted automatically.
PAIRING
Note: Be sure to have the monitor and the camera(s) side by side before pairing.
19