Levana Jena V1 Manual - Manuel (Page 14)

Switching the Camera ON/OFF
Position the camera to view the area you wish to
monitor, angle the camera lens for best view, by
turning it up or down.
1. Slide the POWER switch to the ON
position.
2. The POWER LED on the front of the camera
will light up green. The camera is now ready
to operate.
3. To turn OFF the camera, slide the POWER
switch
back to the OFF position.
Note: When using batteries to power a camera, the POWER LED will flash slowly
if the battery power is low. Replace the batteries or use the power supply.
Night Vision
The camera is equipped with four IR (infrared) LEDs. These LEDs, located on the front
of the camera, allow you to see up to ten feet in complete darkness. Allowing you to
check your baby at any time of night. The night vision LEDs will activate automatically
when the camera detects that the light levels are too low.
CAMERA OPERATION
↑
14
WARNING
•
Alkaline batteries are recommended.
• Place batteries based on the polarity shown inside the battery compartment.
• DO NOT mix different types of batteries and DO NOT mix new and exhausted batteries.
• DO NOT use rechargeable batteries and DO NOT charge non-rechargeable batteries.
• Batteries must be inserted with correct polarity.
• When not using the unit for a prolonged period of time, please remove the batteries to avoid
possible damage caused by leaking batteries.
• DO NOT short circuit the supply terminals of the batteries.
• Exhausted batteries must be removed from the unit.
• DO NOT throw batteries into the fire. They may explode.