Levana Jena V1 Manual - Manuel (Page 17)

Adjusting the VOX* Sensitivity
*VOX = Voice Operated Transmission = Sound Detection
The VOX function causes the camera to transmit video and audio immediately after
a sound is heard. Once transmission begins, the video will play for 10 seconds until
no noise is heard. Pressing a button on the monitor will also turn the screen and
transmission ON at any time. Setting the VOX sensitivity will affect how easily the
video will be transmitted, one bar will require much louder sounds being detected
before transmission will begin, than the five bar setting requires.
1. Press the MENU button four times.
2. The VOX icon will display on the screen along with the current status of
the function, either OFF or a gauge indicating the current
sensitivity, 1-5.
3. Use the UP and DOWN buttons on the left side of the monitor to turn the
VOX function OFF or adjust the sensitivity up and down. One bar being the lowest
and five bars being the highest sensitivity.
Selecting a Lullaby
1. Press the PLAY/PAUSE button on the right side of the monitor once.
2. The LULLABY icon will appear on the monitor screen, and the last played
lullaby will start to play.
3. Press the lullaby button on the right side of the monitor to select one of
five lullabies to play.
4. Press the UP and DOWN VOLUME buttons during playback to adjust the
volume of the music.
5. Press the PLAY/PAUSE button on the right side of the monitor once to turn
OFF the lullaby.
Note: If no number is displayed beside the lullaby icon, all five lullabies will play
in sequence until the PLAY/PAUSE button is pressed again.
MONITOR OPERATION
17