Levana Jena V1 Manual - Manuel (Page 13)

Using the Rechargeable Battery
1.
Turn up the belt clip on the back of the monitor.
2. Remove the battery compartment cover by sliding it
down off the back of the monitor
3. Insert the included rechargeable battery, plug the
battery cord in to the small jack on the inside of the
battery compartment.
4. Slide the battery compartment cover back into place.
Charging the Monitor and Rechargeable Battery
1.
Connect the power adapter from the charging base into an available wall outlet
as shown in the diagram below.
2. With the battery in the monitor, place the monitor into the charging dock with the
screen facing you.
3. The POWER LED will light up red to indicate that the battery is being charged.
4. For safety reasons, ONLY use the adapters included in the package.
5. When monitor’s battery is low, the POWER LED will flash slowly and recharging
the battery will be required shortly after.
SETTING UP YOUR SYSTEM
↑
Note: Baby monitors and cameras with power cords should never be hung on or
near the crib as it is a strangulation hazard. Power cords should be kept no less
than 3 feet away from the crib and the baby’s reach at all times.
13