Thetford N1095 Series Installation Manual - Current - Manuel (Page 7)

Installation Manual 7
Art01676
14
9
11
12
13 15
16
10
17
18
19
19
16
Art01677
20
14
13
12
11
16
9
10
18
17
19
16
19
- Make sure that the baffles are no more than 45° from vertical [20].
- Put one baffle between the top rear edge of the refrigerator and the inside edge of the upper exhaust vent opening.
- Put the other baffle between the outside edge of the upper exhaust vent opening and the side wall of the vehicle.
- If the depth of the enclosure is 24 inches or more and is less than 25 inches, no baffles are necessary at the rear of the enclosure.
- If the depth of the enclosure is 25 inches or more and is less than 26 inches, add two baffles [16] to the rear of the enclosure (See
Art01676 and Art01677).
- Put one baffle 18 inches to 18 1/2 inches above the bottom of the enclosure [17] (4 1/4 inches to 4 3/4 inches above the top of
the lower intake vent opening REF) [18] .
- Put the other baffle at the lowest edge of the condenser [11] of the refrigerator.
- Make sure that the baffles are 1 inch or less [19] from the coils [10] and condenser [11] of the refrigerator.
- Make sure that the baffles are the full width of the inside of the enclosure.