Thetford N1095 Series Installation Manual - Current - Manuel (Page 13)

Installation Manual 13
Reverse the Door Swing-Metal Doors (optional)
This refrigerator has door hinges that allow you to change the direction the door
opens by moving the hinges on a diagonal to the opposite side. Reverse the
door swing before installing the refrigerator in the vehicle.
1. Pull off both the upper [40] and lower [128] trim pieces if they are already
installed (See Art01688 and Art01689).
2. Remove the doors (See Art01684):
- Remove the storage bins from the doors.
- Remove and save both hinge pins [71] from each door.
- Remove and save both hinge bushings [74] from each door.
- Pull the door latch and remove each door away from the
refrigerator.
3. Remove the upper mounting flange and the lower
mounting flange (See Art01683):
- Remove and save the four screws [41] from the upper
mounting flange [212] and from the lower mounting
flange [211].
4. Change the position of the cabinet hinges and the strike
plate (See Art00983 and Art01685):
- Remove and save the screws from the strike plate [65a].
- Remove and save the top and bottom of the three screws
[41] that are beside the strike plate.
- Do not remove the center screw.
- Remove and save the screws [41] from the outside cabinet hinges [250a].
- Put each of these hinges on the other side of the refrigerator [250b].
- Make sure that the offset of these hinges is positioned down on upper cabinet hinge and up
on the lower cabinet hinge.
- Attach each of these hinges with screws.
- Remove and save the screws from the center cabinet hinges [251a].
- Reverse each center hinge and put on the other side of the refrigerator [251b].
- Attach each of these hinges with screws.
211
41
128
208
Art01688
210
40
41
Art01689
Art01684
71
250
74 73
251