Thetford N1095 Series Installation Manual - Current - Manuel (Page 14)

Installation Manual 14
- Remove and save the screw [41] from the front box [68] (See
Art00983).
- Pull the front box away from the refrigerator and out from under
the controls [69].
- Reverse the front box and put it on the opposite side of the
controls.
- Attach the front box to the refrigerator with the screw [41] that
was removed before.
- Put the strike plate on the opposite side of the refrigerator
[65b].
- Put the two screws into the holes that are beside the strike
plate.
5. Change the position of the door handles and the door hinges
(See Art01695 and Art00985):
- Remove the plastic cap that is opposite the upper hinge of the
upper door.
- Remove the cap screw [72] from the door handle [70] and the
door hinges [73].
- Remove the round head screw(s) [41] and door handle from
each door.
- Remove the upper hinge of each door.
- Put each of these hinges on the other side of the door as the
lower hinge.
- Attach each of these hinges with the cap screws that were
removed from the other side.
- The recommended torque for each cap screw [72] is 35 in.-lbs.
- Remove the lower hinge of each door.
- Put each of these hinges on the other side of the door as the upper hinge.
- Attach each of these hinges with the cap screws that were removed from the other side.
- Reverse each door handle and put the lower door handle on the upper door and the upper
door handle on the lower door.
- Attach each door handle with a cap screw [72] and two screws [41].
- Put the plastic cap into the hole that is opposite the upper hinge of the upper door.
Art01683
210
41
41
212
212
211
41
69
68
Art00983