Thetford N1095 Series Installation Manual - Current - Manuel (Page 5)

Installation Manual 5
Art01735
1
2
3
4
5
8
6
7
Key Refrigerator Dimensions
These key refrigerator dimensions are for your reference as
necessary (See Art01735).
Refrigerator cabinet width w/o trim:
23.47 in. max. ............................................................. 1
Refrigerator width overall w/ trim:
24.8 in......................................................................... 2
Refrigerator cabinet to side trim:
0.84 in......................................................................... 3
Refrigerator cabinet height w/o trim:
59.85 in. max. ............................................................. 4
Refrigerator height overall w/ trim:
62.0 in......................................................................... 5
Refrigerator cabinet to top/bottom trim:
1.13 in......................................................................... 6
Enclosure wall to hinges:
3.10 in......................................................................... 7
Refrigerator cabinet to center of handles:
40.5 in......................................................................... 8
Assemble the Enclosure for the
Refrigerator
1. Make sure the enclosure is 59.88 - 60.01 inches high x
23.50 - 23.63 inches wide x 24 inches deep.
2. Make sure the floor is solid and level.
- The floor must be metal or a wood panel and extend the
full width and depth of the enclosure.
- The floor must be able to support the weight of the refrigerator and its contents.
3. Make sure there are no adjacent heat sources such as a furnace vent, a hot water heater vent, etc.
4. If there is more than 1/2 inch between either side of the refrigerator and the inside of the enclosure:
- Fill the space with fiberglass insulation or add a baffle to eliminate the excess clearance.
- Make sure that the rear of the batt-type insulation is between 18 - 19 inches from the face of the enclosure.
- Securely attach the batt-type insulation to the enclosure so that it remains in this position during refrigerator installation, if it
becomes wet, and in windy conditions.