Thetford N1095 Series Installation Manual - Current - Manuel (Page 11)

Installation Manual 11
3. Remove the upper mounting flange and the lower mounting
flange (See Art01683):
- Remove and save the four screws [41] from the upper
mounting flange [210] and from the lower mounting flange
[211].
4. Change the position of the cabinet hinges and the strike plate
(See Art00983 and Art01685):
- Remove and save the screws from the strike plate [65a].
- Remove and save the top and bottom of the three screws [41]
that are beside the strike plate.
- Do not remove the center screw.
- Put each of the outside cabinet hinges [250a] on the other side of the refrigerator [250b].
- Make sure that the offset of these hinges is positioned down on upper cabinet hinge and
up on the lower cabinet hinge.
- Attach each of these hinges with screws.
- Remove and save the screws from the center cabinet hinges [251a].
- Reverse each center hinge and put on the other side of the refrigerator [251b].
- Attach each of these hinges with screws.
- Remove and save the screw [41] from the front box [68] (See Art00983).
- Pull the front box away from the refrigerator and out from under the controls [69].
- Reverse the front box and put it on the opposite side of the controls.
- Attach the front box to the refrigerator with the screw [41] that was removed before.
- Put the strike plate on the opposite side of the refrigerator [65b].
- Put the two screws [41] into the holes that are beside the strike plate.
Art01731
63
64
66
67
Art01683
210
41
41
212
212
211
41
69
68
Art00983