To record over from the middle of an md track, 7 press rec, 8 if necessary, adjust the recording level – Sony MDS-JB930 Manuel d'utilisation
Page 19: 9 press o or ii, 10 start playing the program source, Notes
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

6
If necessary, locate the point on the MD to start
recording from.
If you want to record on a new MD or start recording
from the end of the recorded portion, go to step 7.
To record over from the beginning of an existing MD
track
Turn AMS (or press /►W repeatedly) until the
number of the track to be recorded over appears.
To record over from the middle of an MD track
Turn AMS (or press /►►! repeatedly) until the
number of the track to be recorded over appears, then
press to start playback. Press II at the point you
want to start recording from.
7
Press REC«.
The deck changes to recording pause.
8
If necessary, adjust the recording level.
For details, see "Adjusting the Recording Level" on
page 20.
9
Press O or
I I .
Recording starts.
10
Start playing the program source.
Operations you may want to do during recording
To
Press
Stop recording
■
Pause recording
II
Resume recording after pausing
O o r l l
Eject the MD
EJECT = after stopping
recording
When you pause recording
The track number increases by one. For example, if you
paused recording while recording track 4, the track
number will be 5 when you resume recording.
To prevent accidental erasure of the recorded
material
To make it impossible to record on an MD, slide the
record-protect tab in the direction of the arrow (see
illustration below) to open the slot. To enable recording,
close the slot.
To play the tracks you just recorded
Press O immediately after stopping recording.
The deck starts to play from the first track of the material just
recorded.
Q To play from the first track of the MD after recording
1
Press ■ again after stopping recording.
2
Press O.
The deck starts to play from the first track of the MD.
Notes
• If you switch REC MODE during recording or recording pause,
recording stops.
• Ev'en if you set REC MODE to MONO, the monitor signal
during recording does not become monaural.
• You can't record over existing material when Shuffle Play (page
29) or Program Play (page 30) has been selected. "Impossible"
appears in the display at this time.
X
ID
n
O
3
Ifi
o
3
s
a
(A
1 9 c