Rockwell Automation 1757-ABRIO Installation Instructions - Manuel (Page 9)

Process Remote I/O (RIO) Communication Interface Module 9
Publication 1757-IN916C-EN-P - March 2008
Removing or Replacing the Module
If you are replacing an existing module with an identical one, and you want to
resume identical system operation, you must:
• install the new module in the same slot.
• run the configuration program and download the appropriate
configuration to the module.
Apply Chassis Power
Turn the rack power supply on.
Check Power Supply and Module Status
The rack power supply indicator should be green. The module OK status
indicator should be solid red immediately after you turn on the rack power
supply and then it turns solid green. Refer to the installation instructions for
your particular 1756 rack power supply for recommended actions for
checking your power supply.
Status Display Power-up Messages
The alphanumeric display shows the following messages at power-up.
If the indicator on the 1757-ABRIO module does not cycle through these
messages on powerup, refer to the Troubleshooting section of publication
1757-UM007C , the 1757-ABRIO User Manual.
B#nn Stages in the start-up processes, nn is a hexadecimal number
Boot Next stage in power-up sequence
57ABRIO Ver x.xx.xx Module firmware version