Rockwell Automation 1757-ABRIO Installation Instructions - Manuel (Page 7)

Process Remote I/O (RIO) Communication Interface Module 7
Publication 1757-IN916C-EN-P - March 2008
Install the Module
To install the module, follow these steps.
1. Align the module circuit board with the top and bottom guides in the
chassis.
2. Slide the module into the chassis in the appropriate slot.
Make sure the module properly connects to the chassis backplane.
The module is fully installed when it is flush with the other installed
modules, and the module locking clips click into place.
3. To remove the module, push down on the locking clips at the top and
bottom of each module.
4. Slide the module out of the chassis.
ATTENTION
Do not force the module into the backplane connector. If you cannot
seat the module with firm pressure, check the alignment. Forcing the
module into the chassis can damage the backplane connector or the
module.
43154