Aquascape 50-Watt Underwater Light (01001) - Manuel (Page 4)

4
4) Using Wire Nuts (Fig. 1)
• Split the cable and strip wire insulation,
exposing at least 1/2” of wire on each side.
Repeat for the LVL cable.
• Fill the wirenut with silicone.
• Hold one set of bare wires together and
twist on the wire nut. Repeat for other
wire ends.
• Wrap connection with electrical tape.
5) 50 Watt base (Fig. 2)
• Attach swivel to base and bolt in place.
• Bolts on swivel arms fit into the slots on the
side of the light.
• Tighten down the screws to hold the light
in place.
6) replacing the Bulb (Fig. )
1) Make sure the transformer is unplugged before
changing the bulb. The light housing must be
above water to properly service the light bulb.
2) Unscrew the 4 bolts in the lens cap.
3) Remove the glass lens and o-ring from the
light housing.
4) Using needlenose pliers, remove the tension
springs holding the bulb.
5) Use a thin flat-head screwdriver to pry the
light up and out of the housing.
Note: Removing the halogen light by
pulling the bulb is not recommended.
6) Insert the new bulb by inserting the two
metal plugs into the connector.
Note: Do not touch the halogen bulb found
inside the assembly.
7) Using needlenose pliers, attach the tension
springs to the new bulb.
8) The o-ring and glass lens can now be
installed back into place. Make sure there is
no dirt or debris on the glass, o-ring, and
assembly prior to reassembling.
Glass Lens
O-Ring Seal
Lamp, Halogen
Lenscap
Light Housing
Base Tabs
Base
Figure 1
Figure 2
01001 50W Underwater Light Instr4 4 10/2/06 2:20:13 PM