Aquascape Lily Pad Light (99487) - Manuel

Features
Lily Pad Light
The Floating Lily Pad Light provides a beautiful effect
in your pond, illuminating the surroundings under the
lily pad with a soft, warm glow. The Aquascape LVL
lighting system operates on low voltage and is safe
for use in water features. It is good practice whenever
working in or near water to have all electrical devices
plugged into a ground fault circuit interrupter (GFCI)
that has been installed by a licensed electrician.
Disclaimer
Except as stated below, there are no other representatives or warranties related to the prod-
uct or its use. THE USER SHALL DETERMINE THE SUITABILITY OF THE PRODUCT FOR THE
USER’S INTENDED USE, AND THE USER ASSUMES ALL RISKS AND LIABILITIES WHATSOEVER
IN CONNECTION THEREWITH. Seller and manufacturer’s only obligation is the repair and or
replacement of the submersible light housing as stated below. ALL IMPLIED WARRANTIES
ARE HEREBY EXCLUDED, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MER-
CHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Neither seller nor the manufacturer
shall be liable for any injury, loss, or damage whether direct, incidental, or consequential
arising out of the use or inability to use the product. The national Electric Code, Article 680-
41 (A), requires a Ground Fault Circuit Interrupter (GFCI) to be installed in the branch circuit
supplying fountain equipment rated above 15 volts.
1
YEAR
WARRANTY
1
GARANTIE
DE 1 AN
2
YEAR
WARRANTY
2
GARANTIE
DE 2 ANS
3
YEAR
WARRANTY
3
GARANTIE
DE 3 ANS
1
YEAR
WARRANTY
1
GARANTIE
DE 1 AN
2
YEAR
WARRANTY
2
GARANTIE
DE 2 ANS
3
YEAR
WARRANTY
3
GARANTIE
DE 3 ANS
The submersible light housing is warranted
against defective materials and workmanship
for a period of 12 months from the date of pur-
chase by the user. Contact the installer or place
of purchase if the submersible light housing
should fail within the warranty period. Warranty
shall be totally null and void in the event the
submersible light housing is abused, misused,
or used for a purpose other than for which the
product is intended. No warranty applies to the
light bulb used with the housing.
Made in China for
Aquascape, Inc.
St. Charles, IL 60174 • Brampton,ON, L6T 5V7
www.aquascapeinc.com
item #99487.032006
WarNiNG
The Lily Pad Light is designed for use with the Aquascape 60-watt, 150-watt and 300-watt
LVL transformers. The 60-watt transformer is capable of powering up to 6 lights, the 150-
watt transformer is capable of powering up to 15 lights, and the 300-watt transformer is
capable of powering up to 30 lights. The LVL lighting system operates on low voltage and is
safe for use in water features. It is good practice whenever working in or near water to have
all electrical devices plugged into a ground fault circuit interrupter (GFCI) that has been
installed by a licensed electrician.
Instructions
installing the lights in the pond:
It is easiest to install and conceal the LVL light(s) cords
prior to putting the gravel in the pond. Find a desirable
location for the light(s). Please see Lily Pad Light
Placement diagram to the right for proper placement.
Lily pad light will float freely on the surface of the pond,
providing down lighting. The cord on the unit can be
anchored in place using a small boulder or similar
weighted object. The light cord should have enough
slack to run along the bottom of the pond. You can place
the cord behind any boulder on the vertical walls. Cover
the light cord with gravel on horizontal surfaces.
Troubleshooting
• Double check to see if all of the connections are still
intact and that there are no exposed wires. Ensure
that the wires are fully sealed with the wirenuts.
• The two copper wire stubs at the end of the cut light
cable must not be touching each other. Crossing
wires will cause the transformer to burn-out! Re-
cut if the wires are crossing or the original cut was
not precise.
• Bulb life can be greatly increased by setting timer
on the transformer so the light(s) only operate dur-
ing the desired viewing times. (ex. On at dusk, and
off at 1:00 a.m.)
©2006 aquascape, inc. • all Worldwide rights reserved IDD 06014334-ADI B060122
PackaGe iNcluDes:
• Floating Lily Pad Light
• Wire Nut
• Instructions for Use
also requireD:
• 60*, 150 or 300-Watt
Low Voltage Transformer
(sold separately, *60-watt transformer does not include LVL cable)
Installation Instructions
attaching light to lVl cable using wire nuts:
1) Split the cable and strip wire insulation, exposing at least
1/2” of wire on each side. Repeat for the LVL cable.
2) Fill the wirenut with sillicone.
3) Hold one set of bare wires together and twist on the wire
nut. Repeat for other wire ends.
4) Wrap connection with electrical tape.
Remote Photocell*
Transformer*
Skimmer
BIOFALLS ® Filter
Lily Pad Lights
LVL Cable
Lily Pad Light Placement
Pond
replacing the bulb:
1) Make sure the transformer is unplugged before
changing the bulb. The light housing must be above
water to properly service the light bulb.
2) Pull the plug out of the light tube.
3) Remove the bulb. Note: Do Not touch the bulb
with bare haNDs.
4) Insert the new bulb by inserting the two plugs into the
connector. Note: aGaiN, Do Not touch the bulb
with bare haNDs.
5) Push the bulb assembly back into the light tube.
6) Test to make sure the light works.
7) Position light back into the pond.
Light Tube
Plug
Bulb
* Sold Separately
99487 Lily Pad Light Instruction1 1 7/27/06 7:59:01 AM