Edwards Signaling 869 - Manuel

Installation Instructions for Electronic Horn Signal
Appliances Catalog Series 867, 868 and 869
Description
The horns are high quality signals intended for indoor or out-
door use. It is recommended that these products be installed
in accordance with the requirements in the latest edition of
national and local electrical codes. For outdoor use, the horns
must be installed with a weatherproof backbox.
See Table 2 and Figure 1 for specifications.
Installation
WARNINGS
To reduce the risk of shock, do not connect AC or
battery power to the horn until directed in these
instructions.
To reduce the risk of shock, always disconnect all
power before handling the unit.
1. Select a mounting method as detailed in Figure 1 and
install the electrical box using suitable hardware.
NOTE: Be sure hook flange is facing outward as shown in
Figure 1.
NOTE: The designation "TOP" on boxes denotes
orientation of box after installation.
2. Attach mounting plate using two #8-32 screws provided
with the surface box or four #8-32 screws provided with
weatherproof box. The flush box uses two #8-32 screws
(not provided).
3. Bring the signaling circuit field wiring into electrical box.
Figure 1. Mounting the Horn
Table 1. Horns
Horn, Surface Mount Indoor, Gray 867-*
Horn, Surface Mount Outdoor, Gray 868-*
Horn, Flush or Panel Mount Indoor, Gray 869-*
*The horns are available in two voltages. Insert suffix as
required: N5 = 120V AC, AQ = 24V AC/DC
P-047550-1785 ISSUE 3 © 2000 CHESHIRE, CT 203-699-3000 FAX 203-699-3365 (CUST. SERV.) 203-699-3078 (TECH. SERV.)