Edwards Signaling SA-ETH Ethernet Interface Card - Manuel

© 2013 UTC Fire & Security. All rights reserved. 1 / 4 P/N 3101100 • REV 03 • REB 25JAN13
SA-ETH Ethernet Interface Card
Installation Sheet
EN FR
EN: Installation Sheet
Operation
The SA-ETH card provides a standard 10/100 Base-T Ethernet
network connection for connecting to a local network. The card
can be used for uploading and downloading panel
configuration, history, and current status to a PC running the
configuration utility or connect to a compatible central
monitoring station receiver over a network.
Installation
The Ethernet card is installed on the plastic assembly and
connects to the main circuit board via a ribbon cable.
Note: The Ethernet card must be configured through
programming for proper operation.
To install the Ethernet card:
1. Power down the panel and disconnect the batteries.
2. Locate the card slot on the plastic assembly behind the
main circuit board and connector J1 on the main circuit
board (at the top-right of the main board).
3. Slide the card into the slot on the plastic assembly as
show in the diagram.
4. Attach the card to the plastic assembly using two #6
plastite screws as show in the diagram.
5. Connect the ribbon cable (P/N 7140189) from the card to
connector J1 on the main circuit board. J1 is located on
the top-right of the main circuit board.
6. Connect the network cable. See “Wiring.”
7. Power up the panel and connect the batteries.
Figure 1: Slide the card into its slot
Ethernet card
Top-right of main
circuit board
Card slot on
plastic assembly
Figure 2: Screw the card in place and connect the ribbon cable
To connector J1 on
main circuit board
(top-right of board)
Ribbon cable
#6 plastite
screws