3 third general screen, 4 fourth general screen, Third general screen – MaxPower Corp Gamatronic Power+ M50 Manuel d'utilisation
Page 150: Fourth general screen, Figure 290: general (screen 3), Figure 291: general (screen 4)
Gamatronic Electronic Industries Ltd.
134
POWER+ 3x208 V, User Guide, Release 2.3
8.15.9.3
Third General Screen
From the screen shown in the previous section, press
► to view screen 3:
[3-second Esc > GENERAL >
► > ►]
BOARD JUMPERS SETTING:
1. Not HARD Silicon
2. Silicon Mode 6. No Rmt Pan.
3. CAPACITY HI 9. AC: 120V
Figure 290: General (Screen 3)
A description of the various system parameters shown in screen 3 are listed below.
a.
Not HARD Silicon: Must be HARD only initially, during first activation of non-
configured controller. After production, it should be Not HARD Silicon.
b.
Silicon Mode: Regular mode allowing setup change. The setups are saved in an
EEPROM chip.
c.
CAPACITY HI (LO): High/low battery capacity mode when battery capacity is
more/less than 100 Ah to achieve optimal resolution of the displayed value of battery
current.
d.
No/Yes Rmt Pan: Outputs of system controller are not configured or configured for an
optional remote panel connection.
e.
AC: 220 V: Nominal ac input voltage: 220 V for 2x32 batteries, 110 V for 2x16
batteries in series.
8.15.9.4
Fourth General Screen
From the screen shown in the previous section, press
► to view screen 4.
[3-second Esc > GENERAL >
► > ► > ►]
SYSTEM OPERATION: STANDALONE MODE
REMOTE COMMANDS: DISABLE
BYPASS CONTROL: DISABLE
LINE FREQ./RANGE: AutoHz / 2Hz
Figure 291: General (Screen 4)
A description of the various system parameters shown in screen 4 are listed below.
a.
SYSTEM OPERATION: Indicates either standalone or parallel mode.
b.
REMOTE COMMANDS: These commands can be enable or disabled.
c.
BYPASS CONTROL: This command can be enabled or disabled.
d.
LINE FREQ./RANGE: The line frequency control and its variation range is indicated.