ResMed Flow Generator AutoSet CS 2 - Manuel (Page 33)

29
U SING THE A UTO S ET CS2
E
NG
LI
SH
S ERVICING MENU
This menu displays the following information:
•
SN – the flow generator’s serial number
•
PCB – the flow generator’s PCB number (PCB — printed circuit board)
•
SW – the version of software currently installed on the flow generator.
T REATMENT S CREENS
There are three Treatment screens displayed in the A UTO S ET CS2 LCD. The LCD
will display the Treatment screens when treatment commences, and during treatment
if no key is pressed for 20 minutes.
Press the QuickView key at any point within a menu to display Treatment
Screen 1. You can return to your original screen if you press the QuickView
key again within 20 minutes.
Press the Right key to move from a Treatment screen to the Standby screen.
If an alarm is triggered while you are in the Treatment screens, the arrow will flash.
Press the
Down key until you reach the alarm message.
Scroll through the screens in the usual way, using the Up/Down key.
Figure 17: Treatment Screen 1
Figure 18: Treatment Screen 2
Figure 19: Treatment Screen 3
N OTE
TARG is not a relevant parameter in CPAP mode.
ASV-CS 5.0--15.0
exit
Treatment mode Pressure
LK:18L/min RR:12
APNEA VT: 428
Leak Respiratory rate
Apnoea / Hypopnoea Tidal volume
(if present)
MV:6.2 TARG:5.8
exit
Minute ventilation Target ventilation
eng.book Page 29 Friday, November 3, 2006 2:43 PM