ResMed Flow Generator AutoSet CS 2 - Manuel (Page 11)

7
Q UICK S ETUP G UIDE
E
NG
LI
SH
Q
UICK
S
ETUP
G
UIDE
1 Attach the air tubing and pressure sensor tube to the A
UTO S ET CS2 and
mask (page 11).
2 Attach a humidifier if required (page 13).
3 Switch on the A
UTO S ET CS2. Make sure the mask is unblocked.
4 Select the mask setting (page 26).
5 Perform the Air Circuit Learn function (page 26) at first-time use, or if you
are adding or removing a component of the system (eg a humidifier or anti-
bacterial filter).
6 Fit the mask and commence breathing into it. The S
MART S TART
function
should trigger treatment to commence within the first couple of breaths. If
not, press the Start/Stop key once to commence treatment (page 21).
N OTE
You can observe treatment progress (eg mask leak) via the Treatment screens (page 29).
7 Remove your mask to stop treatment. If S
MART S TOP
is enabled, treatment
will stop automatically. If the S
MART S TOP
function has been disabled, press
the Start/Stop key once.
eng.book Page 7 Friday, November 3, 2006 2:43 PM