ResMed Flow Generator AutoSet CS 2 Manuel d'utilisation
Page 21
17
T
HE
A
UTO
S
ET
CS2 S
YSTEM
E
NG
LI
SH
!
CAUTION
•
Be very careful not to allow water to enter the A
UTO
S
ET
CS2 as this
could affect therapy and/or damage the device.
•
Do not tip the H
UMID
A
IRE
while it is connected to the A
UTO
S
ET
CS2.
If water enters the A
UTO
S
ET
CS2 device, turn off the main power switch at the
back of the unit and unplug it from the power outlet. Return the unit to your
equipment supplier for checking.
•
Set up the H
UMID
A
IRE
and the A
UTO
S
ET
CS2 unit so that the tubing to the mask
runs higher than the machines. This will prevent condensation build-up.
•
If condensation appears in the mask, turn the humidifier settings down.
R
ES
L
INK
™
The R
ES
L
INK
™ is a device that records data onto a SmartMedia™ card during your
therapy. The card can be returned to your clinician so that they can observe your
progress and adjust flow generator parameters if necessary. The R
ES
L
INK
connects to
the back of A
UTO
S
ET
CS2 as shown. For full details on using the R
ES
L
INK
, please refer
to the ResLink User’s Manual.
A
NTI
-
BACTERIAL
F
ILTER
Your clinician may recommend that you use an anti-bacterial filter. A filter should be
placed in the air tubing between the mask and the flow generator. If using a humidifier,
place the filter between it and the flow generator (see Figure 10 below).
Typically, the filter should be replaced daily. Check the filter instructions for full details.
Whenever a filter is added, removed or replaced you must run the Air Circuit Learn
function (see “Learn Circuit” on page 26).
N
OTE
Only hydrophobic anti-bacterial filters should be used with a
H
UMID
A
IRE
2i
or
H
UMID
A
IRE
2i
C.
eng.book Page 17 Friday, November 3, 2006 2:43 PM