Sony TA-VE810G - Manuel (Page 6)

6 GB
Hooking Up the System
IR OUT
Infrared (IR) Repeater Hookups
The IR repeater emits infrared signals corresponding to
those emitted by the remote controls supplied with the
components. Connect the IR repeater if:
• You experience difficulty controlling a certain
component using the on-screen display control.
• Your installation configuration prevents the IR
repeater on the amplifier’s front panel from reaching
all of the components you need to control.
After connecting the IR repeater, set it above or below
the IR sensor on the component(s) to be controlled.
Each IR repeater can send infrared signals to one
component.
Note
Use the supplied adhesive tape to secure the IR repeater so
that its front faces the component to be controlled.
infrared
signals
µ
IR repeater(s)
IR sensor
IR repeater
Component
Audio Component Hookups
If your components are Sony products, connect them to
the jacks as shown in the table on page 15 so that the IR
registration is unnecessary.
What cords will I need?
Audio cord (not supplied)
Ç : signal flow
a CD (to CD player)
b TAPE (to a tape deck)
Amplifier
S-LINK/CTRL A1
e PHONO a CD c DAT/MD b TAPE
White (L)
Red (R)
White (L)
Red (R)
OUTPUT
LINE
L
R
IN
CD
CD player
L
R
RECOUT IN
TAPE
OUTPUT
LINE LINE
L
R
INPUT
Amplifier Tape deck
d TUNER