Sony TA-VE810G - Manuel (Page 14)

14 GB
Setting Up the Remote for On-Screen Control
7
When “PUSH YOUR REMOTE” appears in the
on-screen display, press the button on the TV's
remote that corresponds to the highlighted
control button (e.g., POWER OFF).
• TV/VIDEO : Use to program the cyclic input selector
button on your TV’s remote. This allows you to
switch the TV’s input selector using this unit’s
remote. Do not program an independant input
selector button at this setting.
• WIDE TV DISPLAY MODE: Use to program the wide
TV mode button on your TV’s remote.
When registering the IR code, be sure to do the
following; otherwise, the IR code may not be
registered correctly.
• Point the remote at the IR sensor on the
amplifier from a distance of less than 1 inch (3 cm).
• Hold down the button on the remote for about 2 or 3
seconds until the “RECEIVING” display switches to
“RELEASE YOUR REMOTE”.
• Keep the remote pointed horizontally at the IR sensor
until the code is registered.
8
Repeat step 7 for the remaining buttons that
appear in the on-screen display.
If “NG” is displayed, an IR code was not
registered correctly. In this case, repeat step 7
again.
To return to the main menu
Click EXIT.
To return to a previous menu
Click RETURN.
Note
Some IR codes may not have been successfully registered,
even if “RELEASE YOUR REMOTE” appears on the TV
screen. In this case, try registering the IR code again. If the
IR code still cannot be registered, follow the procedure
described in “Registering Desired Components (User IR
setting)” on page 28.
Erasing TV IR codes
Click CODE CLEAR in the TV IR SET menu that
appears when you click START.
• To erase a specific IR code
1 Click SINGLE IR CODE CLEAR.
“SELECT CLEAR CODE KEY” appears.
2 Click the button you want to clear.
“Are you sure?” appears.
3 Click YES to erase the code.
To cancel erasing, click NO.
To erase another code repeat steps 2 and 3.
• To erase all the TV IR codes
1 Click TV IR CODE CLEAR.
“Are you sure?” appears.
2 Click YES to erase the codes.
“CODE CLEAR!” appears in the display.
To cancel erasing, click NO.
IR sensor
TV's remote
TV IR SET
TV IR SET CHANNEL 0
POWER OFF
PUSH YOUR REMOTE
CODE CLEAR
EXIT RETURN
WIDE TV DISPLAY MODE
TV / VIDEO