Whirlpool 29 Inch Electric Dryer Use and Care Guide - Manuel (Page 8)

8
6.
Press PUSH to START
to begin cycle
Push and hold the PUSH to START knob to begin the cycle.
Promptly remove garments after cycle has completed to reduce
wrinkling. Use the Wrinkle Shield™ feature to avoid wrinkling
when you are unable to remove a load from the dryer as soon
as it stops.
4.
Set cycle settings and options
Select cycle settings and options by turning the knob to the
desired position.
NOTE: Not all options and settings are available with all cycles.
Temperature
Turn the Temperature knob to change the drying temperature
setting. See “Setting the Drying Temperature”.
Wrinkle Shield™ feature (on some models)
■ Get 90 minutes of heat-free, periodic tumbling at the
end of a cycle. Turn the Wrinkle Shield™ knob to select
on or off at any time before the cycle has ended.
■ Some models with a Wrinkle Shield™ cycle will
automatically get 40 minutes of heat-free, periodic
tumbling at the end of a cycle.
3.
Select the desired cycle
Select the desired cycle for your load. See the “Cycle Guide”
for more information about each cycle.
ACCUDRY™/Automatic Dry Cycles
You can select a different dryness level, depending on your
load, by turning the knob to dryness level.
Selecting More or Very Dry, Normal, ENERGY PREFERRED or
Less Dry automatically adjusts the dryness level at which the
dryer will shut off. Once a dry level is set, it cannot be changed
without stopping the cycle.
ACCUDRY™/AUTOMATIC DRY cycles give the best drying in
the shortest time. Drying time varies based on fabric type, load
size, and dryness setting.
NOTE: More or Very Dry removes more load moisture.
ENERGY PREFERRED or Normal is used for a starting point for
ACCUDRY™ cycles. Less Dry removes less moisture
and is used for loads you may want to put on a hanger
to complete drying.
NORMAL
5.
Select Cycle Signal (if desired)
Turn the Cycle Signal knob to select the desired setting
(On or Off). The Cycle Signal produces an audible sound
when the drying cycle is finished. Promptly removing clothes
at the end of the cycle reduces wrinkling.
NOTE: When the Wrinkle Shield™ setting is selected and the
Cycle Signal is On, the tone will sound every 5 minutes until
the clothes are removed, or the Wrinkle Shield™ setting ends.
Control panel and cycles may vary, depending on model.