Epson 3000 - Manuel (Page 33)

Plugging In the Printer
1. Make sure the printer is turned off. It is off when the surface
of the
2
Operate button is even with the button protectors
beside the button, as shown.
2. Check the label on the back of the printer to make sure
the voltage required by the printer matches that of the
electrical outlet you will be plugging it into. Also, make
sure that you have the correct power cable for your
power source.
c
Caution:
It is not possible to change the printer’s voltage. If the
rated voltage and your outlet voltage do not match,
contact your dealer for assistance. Do not plug in the
power cord.
3. If the power cord is not attached to the printer, connect it to
the AC inlet on the back of the printer.
4. Plug the power cord into a properly grounded electrical
outlet.
Operate
Pause
5 Sec
Ink Ou
Paper Out
Reset
LF/FF
a-301-e
2
R
Loire-P Ref. Guide
Rev.c
A5 size Chapter 2
02-24-97 DR, pass 0
Getting Started 2-7