Weston 10" Meat Slicer - Manuel (Page 10)

-10-
ASSEMBLY INSTRUCTIONS
1. Attach the gauge plate to the unit by
inserting the (2)screws through the holes
in the plate support, affixing the washers
and cap nuts from the back of the unit
(Figure 10).
2. Attach the blade support by lining up
the support with the motor housing and
turning the nut clockwise (from front of the
unit), using a #10 wrench, until the washer
is tight against the housing.
3. Secure the blade support by securing
the bolt through the top of the motor
housing (Figure 11). Tighten the bolt with
a #10 wrench. Place the recessed nuts
in the blade support (Figure 11). Screw
the Phillips head screws into the holes
through the back of the blade support.
Use your finger to secure the nut while
threading the screw.
4. Attach the blade, lining up the screw
holes on the blade with the screw holes in
the motor housing. Secure 3 screws using
a Phillips screwdriver. (Figure 12)
5. Affix the plate to the center of the blade
(aligning the square peg with the square
hold) and secure with the Blade Locking
Screw w/ Knob through the back of the
motor housing. (Figure 13)
6. Mount the sliding food carriage by lining
up the hole on the carriage with the bolt
on the front of the sliding arm. Secure the
locking knob to the bolt on the front of the
unit.
7. Attach the plastic guard to the inside
of the sliding food carriage so that the
screws are inserted through the plastic
from the blade side of the unit. Secure the
pusher in place by screwing the cap nuts
onto each screw.
HANDLE CAREFULLY!
KEEP FINGERS AWAY FROM THE BLADE!
NEVER FEED FOOD BY HAND.
ALWAYS USE THE FOOD PUSHER!
Always use completely assembled Meat Slicer
with Food Carriage and Food Pusher.
Protective/cut-resistant Kevlar gloves are recommended
whenever handling the Blade!
WARNING!
SHARP BLADE
WARNING!
Before cleaning, assembling or disassembling the
appliance, make sure the appliance is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
Figure 10
Figure 11
Figure 13
Figure 12
CAUTION
SHARP Blade
Blade
Locking
Screw