Labconco Protector XStream Laboratory Hoods 11081 Series - Manuel (Page 38)

Chapter 7: Modifying Your Protector XStream
Product Service 1-800-522-7658 34
Original instructions
Installing Ceiling Enclosures Above the
Fume Hood
Your Protector XStream Fume Hood has mounting holes to accept a ceiling
enclosure to close off the area between the top of the hood and the ceiling.
Contact Labconco Customer Service for ordering information.
Figure 7-2
Installing Rear Panels Behind the Fume
Hood
Your Protector XStream Fume Hood can be modified to add a rear panel behind
the fume hood when the fume hood is placed on an island. Contact Labconco
Customer Service for ordering information.
Installing Additional Service Fixtures
Additional service fixtures can be installed in the available service fixture holes in
both sidewalls and corner posts. The fume hood is factory set to accept up to four
valves per side. Contact Labconco Customer Service for information.
Figure 7-3 Knob Figure 7-4 Valve Figure 7-5 Hose Connector