Unpacking your laboratory fume hood, Removing the shipping skid – Labconco Protector XStream Laboratory Hoods 11081 Series Manuel d'utilisation

Page 14

Advertising
background image

Chapter 3: Getting Started

Product Service 1-800-522-7658

10

Original instructions

la surface de travail. Ne pas soulever par l’écoulement d'air du
devant.

Unpacking Your Laboratory Fume Hood


Carefully remove the shrink-wrap or carton on your fume hood and inspect it for
damage that may have occurred in transit. If your unit is damaged, notify the
delivery carrier immediately and retain the entire shipment intact for inspection
by the carrier.

DO NOT RETURN GOODS WITHOUT THE PRIOR
AUTHORIZATION OF LABCONCO. UNAUTHORIZED
RETURNS WILL NOT BE ACCEPTED.

IF YOUR HOOD WAS DAMAGED IN TRANSIT, YOU MUST
FILE A CLAIM DIRECTLY WITH THE FREIGHT CARRIER.
LABCONCO CORPORATION AND ITS DEALERS ARE NOT
RESPONSIBLE FOR SHIPPING DAMAGES.


Do not discard the shipping skid or packing material for your fume hood until you
have checked all of the components and installed and tested the unit. The
XStream fume hood baffles are shipped loose behind the hood and do not
discard. The lower baffle is 12.9" tall and the middle baffle is 27.4" tall. See
Figure 1-1, Figure 3-1 and Figure B-1 that shows proper XStream baffle
installation.
Do not remove the fume hood from its shipping skid until it is ready
to be placed into its final location. Move the unit by placing a flat, low dolly
under the shipping skid, or by using a floor jack.

Do not move the hood by tilting it onto a hand truck.

Ne pas déplacer la hotte en le penchant sur un diable.

Removing the Shipping Skid

LEAVE THE FUME HOOD ATTACHED TO ITS SHIPPING
SKID UNTIL IT IS AS CLOSE TO ITS FINAL LOCATION AS
POSSIBLE. MOVE THE HOOD BY USING A SUITABLE
FLOOR JACK, OR BY PLACING A FURNITURE DOLLY
UNDERNEATH THE SKID. DO NOT MOVE THE HOOD BY
TILTING IT ONTO A HAND TRUCK.


After you verify the fume hood components, move your hood to the location
where you want to install it. Follow the steps listed next to remove the shipping
skid from your unit.


1. Remove the side panels by unscrewing the concealed screw. Then lift

off the side panels.

The United
States
Interstate
Commerce
Commission
rules require
that claims be
filed with the
delivery
carrier within
fifteen (15)
days of
delivery.

!

Advertising