Labconco WaterPr RO Systems 90750 Series - Manuel (Page 21)

Chapter 3: Getting Started
17
Original Instructions
WaterPro PS and Glassware Washer Feed
The WaterPro RO can be used to feed purified water to the WaterPro PS Polishing System and
Labconco’s Glassware Washers. To make the connection(s), first empty the storage tank of stored
water. Remove a gray plug located on the bottom of the storage tank and insert tubing from either
the Glassware Washer or the WaterPro PS. Connection of both the PS and Glassware Washer can
be made with the use of a tee.
Both the 14 Gallon (9203001) and 20 Gallon (9203000) Storage Tanks included the tubing
required for connection to a Labconco WaterPro PS System or a Labconco Glassware Washer.
NOTE: If no optional storage tank is connected to the RO system the
Glassware Washer will require the units 17L storage tank to be full at the
beginning of the purified rinse cycle. If more than one pure rinse cycle is
selected the RO system will need to be producing additional pure water in
order to completely fill the washer for a second pure rinse. Use of RO water
from the 17 liter tank or dispense valve during the washer rinse cycle may
result in a short fill for the washer. While the storage tank is filling with water
the flow rate to the dispense valve will be diminished. If multiple pure rinse
cycles are required one of the optional storage tanks should be used.