Labconco WaterPr PS Systems 90007 Series - Manuel (Page 45)

Appendix C: WaterPro PS System Specifications
41
Original Instructions
HPLC/UF Hybrid models
915 Grains as CaCO
3
Deionization: High Purity Polishing grade mixed bed resin,
which will deliver 16 to 18.2 Megohm.cm Type I
water.
Ultrafiltration:
(membrane included on UF models) Polysulfone membrane in a spirally wound
configuration.
Final Filtration (Optional): Self-venting 0.2 micron hollow fiber filter
Electrical Specifications: 115V, 60 Hz, 5.0 Amps or 230V, 50 Hz, 2.5 Amps
Single Phase
Relative Humidity: Less than 80%
Environmental Conditions:
The WaterPro PS is designed to operate safely under the following conditions:
• Indoor use
• Altitude up to 2,000M (6,562 Ft.)
• Ambient temperatures 5°C to 40°C (41°F to 104°F)
• Maximum relative humidity 80% for temperatures up to 31°C (88°F) decreasing linearly to
50% relative humidity at 40°C (104°F)
• Main supply voltage fluctuations not to exceed ±10% of the nominal voltage
• Transient over-voltages according to installation category II (over-voltage categories per
IEC 1010)
• Pollution degrees 2 (Normally only non-conductive foreign matter, solid, liquid, or gaseous
(ionized gases), that may produce a reduction of dielectric strength or surface resistivity
occurs. Occasionally, however, a temporary conductivity caused by condensation must be
expected, in accordance with IEC 664)