Labconco WaterPr PS Systems 90007 Series - Manuel (Page 20)

Chapter 3: Getting Started
16
Original Instructions
4. If the optional filter Catalog number 9092900 has been ordered, remove it from its plastic
bag and thread it into either the dispense valve or the gun. The nozzle on the valve or gun
must be removed before installing hollow fiber final filter. Orient filter as shown on label.
HAND TIGHTENS ONLY. Reference Figure 4.
5. Install the bowl. Do not over tighten.
6. Connect the tubing into the elbow. A firm tug on the tubing should not pull it out.
7. Connect a drain line to the dispensing valve.
8. Set timed dispense for 1.5 hours and start unit. After time runs out unit will automatically
shut off. (Be sure prefilter and carbon/prefilter are in place).
9. Unit is ready for operation.
Figure 4