RCA VR270 - Manuel (Page 25)

|51 The display will prompt you to select either
AM or PM.
NOftKAl \
CH 04
TIME OR «
; 4.M. I R«.2 •
TIME OFF ‘J.' '
START MTE
TO EXO RUSH RROGRAH
Press *T" for AM or “2” for PM.
Remember 12 AM is midnight
12 PM is noon
|61 The display will prompt you to select the
stopping time.
NORMAL PROORAM I
CH 44
TIMi OR 04:00 PM
TIME OFF 'i.;. -­
START DATE
TO ENO PUSH PROGRAM
Press four digits, two for the hour and two
more for the minute. For example, press 0 8 0
5 for 8:05. (Always press “0” before a single­
digit hour or minute.)
m The display w’ill prompt you to select either
AM or PM.
NORMAL PROGRAM 1
CM 04
TIME ON 06'Ofl PM
TIME OFF ,
;Air«1 PM«2y
START OAlt
TO ENO PUSH PROGRAM
Press “1” for AM or “2” for PM.
Remember 12 AM is midnight
12 PM is noon
The display will show “START DATE”
181 followed by the current or next date and day.
If you want to start recording on that day,
skip to Step 9.
NORMAL PROGRAM 1
CH 04
TIME ON 06:DD PH
TIME OFF 41:0S PM
START DATE 'o'e/43/SI
PIE0
TO ENO PUSH program
If you want to start recording on a future
date, press four digits (two for the month and
two for the day). Press “0" first for a single­
digit month or day. For example, press 0 8 0
4 to begin recording on August 4.
The year and day of the w-eek are displayed
automatically when you finish.
jqi Press PROGRAM to enter your program and
return to the original display. Additional
programs may be entered by repealing steps
2-9.
TO SELECT MODE
PUSH NUHSER SHOWN
1 CLOCK SET
3 NORMAL PROGRAM
3 OAILYIW-FI PROGRAM
4 WEEKLY PROGRAM
5 PROGRAM REVtEW
TO END PUSH PROGRAM
if you have no other programs to enter, press
PROGRAM again.
1101 Turn ofT the VCR.
- Checking the Timer Programs
Programs can
turned on. be checked whenever the VCR is
3.
Press PROGRAM on the remote control to
display the programming menu.
Press 5 (Program Review).
The TV screen w'il! display for ten seconds the
information you entered for the lowest program
number. Then the display changes to the next
higher program number, and so on, until all
program information has been displayed.
Press 5 again if you want to view the next
program information without wailing ten
seconds.
When you are finished, press
remove the on-screen display. PROGRAM to
- Clearing a Timer Program-----------------------------
Press PROGRAM on the remote control to
display the programming menu.
Press 5 (Program Review').
The TV screen will display for ten seconds the
information you entered for the lowest program
number. Then the display changes to the next
higher program number, and so on, until all
program information has been displayed.
Press 5 again if you want to view' the next
program information without waiting ten
seconds. .
Press CLEAR when the program information
you want to clear is displayed.
Press PROGRAM to remove the on-screen
L
5.
display.
Notes:
• Normal timer programs clear automatically when the
recording is finished, but daily and weekly programs
remain in the timer indefinitely.
• All programs are erased if power is interrupted.
• More information about Timer Recording is on the
next page.
23