RCA VR270 - Manuel (Page 16)

Remote Control
Before you use the remote control unit supplied with
your VCR, install the batteries (instructions below).
Several of the remote’s buttons do the same things as
buttons with the same names on the top of your VCR,
and you can use whichever one is more convenient at the
moment.
The remote control has additional buttons for
controlling some of the VCR's special features, and it is
also used for setting the clock and programming the
timer.
Since the remote control operates the VCR by infrared
light, it is immune to electrical and .sound interference.
However, you must aim the remote control directly at
the VCR. There cannot be any obstructions between
them.
Battery Installation-------------------------------------
The batteries supplied with your remote control are
packed separately. Here’s how to install them;
1. Turn the remote control over and remove the
cover of the battery compartment,
2. Insert the batteries so that their positive ( + )
ends contact the positive terminals in the battery'
compartment. These are marked ( + ) in the
bottom of the compartment.
3. Replace the cover.
Remote Control
(BacK View)
Notes;
• Never place anything heasy on top of the remote
control or lay it upside-down. This may acci­
dentally depress the buttons for a long time and
discharge the batteries.
• Replace the batteries when the VCR fails to
respond to the remote control.
• Remove the batteries from the remote control if it
will not be used for a month or more. This will
prevent possible damage from battery leakage.
Location and Function of
Remote Control Buttons
POWER Button; Turns the VCR on and off. (If the
VCR is off. inserting a cassette will automatically
turn it on.)
(¿) Number Buttons (0 through 9): Select any channel
(whether or not it is in the Tuner Scan List) by
pressing two buttons. (Press 0 and then 8 for
Channel 8.) The numbered buttons are also used
for setting the clock and programming the timer.
Channel A and ▼ Buttons: Use these buttons to
select the next channel up or down programmed in
the scan list.
The VCR tuner must be programmed for the
Channel
A and ▼ buttons to woric. Details are on
page 12.
®
PROGRAM Burton: Used to set the clock and
program the timer with use of the on-screen display
on your TV.
PA USE Button: Pressing the PA USE button
during recording stops the tape so that nothing will
be recorded. When you press the PAUSE button
again, recording resumes immediately.
Pressing PAUSE during playback produces a stop-
action picture, and pressing it again resumes
normal playback. Details are on page 20.
6) CLEAR Button; Used to clear incorrect
information when programming the timer. Also used
to dear a timer program or to reset the Tape Counter
to “0000”.
©
DISPLA y Button; Controls on-screen displays.
• Press once to bring normal displays to TV
screen.
• Press twice to display Tape Counter and turn on
counter memory.
• Press three times to remove all displays from TV
screen.
14