GE ZGU385NSMSS - Manuel (Page 15)

Installation
Instructions
Convert Natural Gas Model ZGU385NSMSS
to LP Gas Operation
If sold outside the U.S. and Canada:
A
w
ARNING:
If you wish to use this product
with Liquefied Petroleum (LP) gas containing greater
than 10% butane, you must purchase the butane
conversion kit#WB28T10237.To order, please call
1.888.554.8403 or 1.787.275.4051.
SAFETY INFORMATION
The pressure regulator and burner orifices are set for
natural gas operation.
To convert this cooktop from natural gas operation to
LP operation, the regulator and burner orifices must be
converted. LP burner orifices are attached to the regulator
along with separate LP conversion instructions.
A CAUTION
— The cooktop, as shipped from the
factory, is set for use with its intended gas. If you wish to
use your cooktop with the alternate gas, you must first
replace the orifices and convert the pressure regulator.
AWARNING
— This conversion must be
performed by a qualified installer or gas supplier in
accordance with the manufacturer's instructions and
all codes and requirements of the authority having
jurisdiction. Failure to follow instructions could result in
serious injury or property damage. The qualified agency
performing this work assumes responsibility for the
conversion.
A CAUTION
— The following adjustments must
be made before turning on the burner. Failure to do so
could result in serious injury. Be sure pressure regulator
has been converted as described in Step 1.
1 ADJUST THE REGULATOR
A. Disconnect all electrical power, at the main circuit
breaker or fuse box.
B. Shut off the gas supply to the cooktop by closing the
manual shut-off valve.
C. Adjust the pressure regulator by the following
Instructions:
• Unscrew the cap.
• Carefully look at the spring retainer to locate the NAT
or LP position.
• Turn the spring retainer over by rotating it 90
deg., pull it from the cap, turn the spring retainer
over so that LP is showing, insert it back into the
cap, and then rotate it 90 deg. into position.
• Screw the cap back onto the regulator and
tighten.
Ton Gasket
Spring
Retainer
L.P./Propane
Position
Pressure Regulator
TOOLS YOU WILL NEED FOR
CONVERSION
Crescent wrench
7mm nutdriver
Safety glasses
(_____ i!.— -■
Small flat-head
screwdriver
(2 to 2.4 mm or 3/32"
tip size, 50 mm or
2-3/8"long)
Burner
head
^ CHANGE BURNER ORIFICES
INSTALLATION TIP: First remove all Burner cap
orifices and then start replacing them.
This will help to prevent the possibility
that some may not be replaced.
A. Remove the burner grates,
burner caps and burner heads.
B. Use pliers to hold the orifice in
position during initial thread
engagement or final removal to avoid
dropping the orifice in the n i ■ 'x
cooktop Use the 7mm nut Spark igniter
driver to tighten or loosen. There
are two orifices per burner.
The main orifice is located low
in the center of the burner, while
the simmer orifice is located
higher beside the center of the
burner.
Burner
base
Simmer
orifice
Main
orifice
15