GE PGP966DETBB Manuel d'utilisation
Installation instructions, 36" sealed gas cooktop, Important
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Installation
Instructions
36" Sealed Gas Cooktop
JGP633, JGP970, PGP966, ZGU36
Questions? Call 800.GE.CARE5 (800.432.2737) or Visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or Visit our Website at:
IN THE COMMONWEALTH OF
MASSACHUSETTS:
• This product must be installed by a licensed
plumber or gas fitter.
• When using ball-type gas shut-off valves, they
shall be the T-handle type.
• A flexible gas connector, when used, must not
exceed 3 feet.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT
— Save these instructions
for local inspector's use.
• IMPORTANT
— Observe all governing
codes and ordinances.
• Note to Installer - Be sure to leave these
instructions with the Consumer.
Note to Consumer ■
future reference.
Keep these instructions for
• Product failure due to improper installation is not
covered under the Warranty.
A WARNING
— This appliance must be
properly grounded.
. IMPORTANT
— Leak testing of the
appliance shall be conducted according to the
manufacturer's instructions.
• Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
A WARNING
— Disconnect all electrical
power at the main circuit breaker or fuse box
before installing.
FOR YOUR SAFETY:
awarning
— If the information in this
manual is not followed exactly, a fire, explosion
or gas leak may result causing property damage,
personal injury or death.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance!
Do not install this product with an air curtain hood
or other range hood that operates by blowing air
down on the cooktop. This airflow may interfere
with operation of the gas burners resulting in fire or
explosion hazard.
WHAT TO DO IF YOU SMELL
GAS:
• Do not try to light any appliance. Do not touch
any electrical switch; do not use any phone in
your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the fire
department.
Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
This cooktop has been design certified by CSA
International. You'll find safety precautions in your
Owner's Manual.
Read them carefully.
• Installation of this cooktop must conform with
local codes or, in the absence of local codes with
the National Fuel Gas Code, ANSI Z223.1/NFPA
54-Latest edition.
• Be sure your cooktop is installed properly by a
qualified installer or service technician.
• To eliminate reaching over surface burners,
cabinet storage above burner should be avoided.
• Do not install the unit near an outside door or
where a draft may affect its use.
31-10851-1
(08-12 GE)
Document Outline
- Installation
- Instructions
- IN THE COMMONWEALTH OF
- MASSACHUSETTS:
- BEFORE YOU BEGIN
- FOR YOUR SAFETY:
- WHAT TO DO IF YOU SMELL GAS:
- ELECTRICAL REQUIREMENTS
- MATERIALS YOU MAY NEED
- IT] LOCATE ELECTRICAL OUTLET AND GAS SHUT-OFF VALVE BENEATH CABINET
- IT PROTECT SURFACE OF COOKTOP
- T ATTACH FOAM TAPE
- IT LOCATE MOUNTING PARTS
- T ATTACH BRACKETS TO COOKTOP
- T INSERT COOKTOP INTO CUTOUT
- IT] PROVIDE ADEQUATE GAS SUPPLY
- IT INSTALL REGULATOR
- T INSTALL REGULATOR ONTO BURNER BOX BOTTOM
- T COMPLETE CONNECTION WITH A COUPLING
- H CHECK FOR LEAKS
- H INSTALLATION OVER BUILT-IN OVEN
- [H EXTENSION CORDS
- H ELECTRICAL SUPPLY AND OUTLET
- [El TWO-PRONG WALL RECEPTACLE
- IT] ASSEMBLING THE COOKTOP BURNERS
- \Y\ CHECK IGNITERS
- H BURNER IGNITION
- H THE BURNER FLAMES
- IE BURNER GRATES
- IF SOLD OUTSIDE THE U.S. AND CANADA:
- [H SAFETY INFORMATION YOU SHOULD KNOW
- \Y\ ADJUST YOUR COOKTOP FOR USE WITH LP GAS
- H CHANGE COOKTOP BURNER ORIFICES
- [El CHANGE COOKTOP BURNER ORIFICES (CONT.)
- H CHANGE COOKTOP BURNER ORIFICES (CONT.)
- ADJUST BURNER FLAMES
- Instructions
- d'installation
- AVANT DE COMMENCER
- POUR VOTRE SECURITE
- Cl QUE VOUS DEVEZ FAIRE SI VOUS SENTEZ LE GAZ :
- BESOINS D'ELECTRICITE
- MATERIAUX DONT VOUS POUVEZ AVOIR BESOIN
- [T] FOURNISSEZ UN BON
- APPROVISIONNEMENT EN GAZ
- H INSTALLEZ LE RÉGULATEUR
- \j£\ INSTALLEZ LE RÉGULATEUR EN BAS DE LA BOÎTE DE BRÛLEURS
- H VÉRIFIEZ QU'IL N'Y A PAS DE FUITE
- H INSTALLATION SUR UN FOUR ENCASTRÉ
- [T] RALLONGES
- |Y| ALIMENTATION ÉLECTRIQUE ET PRISE
- H PRISE BIPHASÉE
- [T] ASSEMBLEZ LES BRÛLEURS DE LA TABLE DE CUISSON
- [2] VÉRIFIEZ LES ALLUMEURS
- H ALLUMAGE DES BRÛLEURS
- H LES FLAMMES DU BRÛLEUR
- H GRILLES DE BRÛLEUR
- H CHANGEZ LES DIAPHRAGMES DES BRÛLEURS DE LA TABLE DE CUISSON (Suite)
- Щ AJUSTEZ LES FLAMMES DES BRÛLEURS