GE ZGU385NSMSS - Manuel (Page 11)

Installation Instructions
I 4 I ASSEMBLE BURNERS,
CHECK IGNITION (cont.)
F. Turn on each burner. On LP models, flames
should be blue in color but may have yellow
tips. Natural gas models should have soft, blue
flames. The burner flames should not flutter or
blow away from the burner. The flame should be
no less than 1/4" on the lowest setting and no
greater than 1-1/2" on highest setting.
1/4" to
1 - 1 / 2 "
Cooktop burner
Burners should be checked frequently
A WARNING:
If you attempt to measure
the flame, please use caution. Burns could result.
G. The three cooktop grates are designed for
specific positions. For maximum stability,
these grates should only be used in their proper
positions: they should not be interchanged.
Position the two side grates with locking rails
toward the center grate so that a continuous
"arc" is formed with the center ribs of all three
grates. Make sure the center grate is locked into
position over the rails on the side grates and
that all the grates are stable and level.
"OUTSIDE"
edge
"OUTSIDE"
edge
OPERATION CHECKLIST
1. Make sure all controls are left in the OFF
position.
2. The serial plate for your cooktop is located
on the bottom of the burner box. In addition to
the model and serial numbers, it tells you the
ratings of the burners and the type of fuel and
pressure the cooktop was adjusted for when it
left the factory.
3. When ordering parts, always include the serial
number, model number and a code letter to
ensure proper replacement parts.
4. Check again to be sure all installation
procedures have been completed.
11