Rs485 setting, Notes, Assemble the camera – Panasonic WV-CS554 Manuel d'utilisation
Page 51: Precaution, A. sideway cable exit, B. top cable exit
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
RS485 Setting
The 4-bit DIP switch in used for
RS485 termination.
4-bit DIP SW
ON
□
1
E □ □
2
3
4
BP 1
Function
Switch
position
ON
Termination ON
OFF
Termination OFF ’
BP 2 BP3 BP 4
Function
Switch
position
ON
ON
ON
Flalf duplex (2 line)
OFF OFF OFF Full duplex (4 line) *
Notes:
• Defaults are marked with *
• BP stands for Bit Position.
• Daisy chain connection is not available for
Full Duplex. (Only for Panasonic's system
controllers)
3. Assemble the Camera
Reverse the disassembly procedure. Take
care not to cut any cables.
- Precaution -------------------------------------------
Be sure to select a ceiling board strong
enough to support 4 times the total weight of
the camera.
a. Sideway Cable Exit
Prepare a cutout in the diecast case and
decoration cover as shown in the following
figures.
Note: Remove sharp edges to protect the
cables.
b. Top Cable Exit
Prepare a hole in the ceiling board to run
the cables.
1. Mark the mounting holes on the ceiling,
using the removed camera mounting base
as a template.
Marking
2. Fix the camera mounting base to the ceiling
with four screws (not provided, M4).
51