Panasonic DVD-C220D - Manuel (Page 43)

3
Press the cursor buttons (A, T) to select
the preferred value and press SELECT.
When “1 LPCM 96k^48k” is selected
1 No: Digital audio of 48 kHz/16 bit is output during
piayback of the DVD recorded in Linear PCM of
48 kHz. No digital audio is output during play­
back of the DVD recorded in Linear PCM of
96 kHz. However, audio wili be output using the
original audio recording system in case of the
DVD which has not been copyright-protected.
(Factory preset)
2 Yes: During playback of the DVD recorded in Lin­
ear PCM of 48 kHz or 96 kHz, digital audio con­
verted to 48 kHz/16 bit is output.
(Digital output of PCM audio is restricted to
48 kHz/16 bit or below for copyright protection.)
When '*2 Dolby Digital” is selected
1 Bitstream*^ Dolby Digital (AC-3) bitstream (Ich-
S.lch) is output during playback of the
DVD recorded in the Dolby Digital
(AC-3). (Factory preset)
Select this setting when the player is
connected to the Dolby Digital (AC-3)
decoder.
Digital audio converted to PCM (2ch) of
48 kHz/16 bit is output during playback
of the DVD recorded in the Dolby Digital
(AC-3).
is selected
No digital audio is output during play­
back of the DVD recorded in dts.
(Factory preset)
dts bitstream is output during playback
of the DVD recorded in dts. Select this
setting when the player is connected to
the dts decoder.
The screen illustrated in step 1 is displayed. Select “0" by us­
ing the cursor buttons ( A , T ) and press SELECT to return to
the initial settings screen.
Also refer to “Common procedures of initial settings" on
page 36.
2 PCM:
When “3 dts
1 Off:
2 Bitstream^
Recommended setting of “Digital Audio Out­
put”
Make settings as shown in table below depending on the kind
of equipment that is connected to the optical/coaxial digital au­
dio output connector.
Type of equipment
to be connected
Recommended setting
1 LPCM
96k^48k 2 Dolby
Digital
3 dts
No equipment is
connected
No Bitstream Off
AV amplifier (with
digital audio input
connector) without
Dolby Digital/dts
decoder
Yes*“2 PCM«’’ Qif«i
Dolby Digital (AC-3)
decoder
(See page 16.) Yes*2 Bitstream Qif
Dolby Digital (AC-3)
decoder/dts decoder
(See page 16.)
Yes*2 Bitstream Bitstream
• Underlined items are a factory preset.
*' When connecting an amplifier (with an optical/coaxial digital
input connector) which does not contain the Dolby Digital
(AC-3) or dts decoder, be sure to select “PCM” at the “2 Dol­
by Digital” and “Off at the “3 dts”. If “Bitstream” is selected,
any attempt to play DVD may cause such a high level of
noise that it may be harmful to your ears and damage your
speakers.
*2 Audio output from the player’s audio output connectors is
converted to 48 kHz as well as audio from the digital audio
output connector.
To enjoy high quality sound at 96 kHz, connect the amplifier
or decoder directly to the audio output connectors, not to the
digital audio output connector. (Select "No” at the “1 LPCM
96k^48k".)
43