If an error message appears during installation, Installing the software (continued) – Sony DVBK-1000 Manuel d'utilisation
Page 14
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Installing the software (continued)
Note
The Board Setup
automaticallv detects the
selected I/O port address.
If an error message appears during
installation
Depending on the message, operate as follows:
When "I/O port address of the board overlaps with
other boards" appears
In this case, you have to change the port address.
Follow the procedure below to change the address.
1 Turn off the power on your PC.
2 Remove the capture board.
3 Set DIP switches.
Usable port addresses are as follows:
Port
address
SW1 SW2 SW3 SW4
Port
address
SW1 SW2 SW3 SW4
0700H
OFF OFF OFF OFF
0780H
ON
OFF OFF OFF
701 OH
OFF OFF OFF ON
0790H
ON
OFF OFF ON
0720H
OFF OFF ON
OFF
07A0H
ON
OFF ON
OFF
0730H
OFF OFF ON
ON
07B0H
OX
OFF ON
ON
0740H
OFF ON
OFF OFF
07C0H
ON
ON
OFF OFF
0750H
OFF ON
OFF ON
07D0H
ON
ON
OFF ON
0760H
OFF ON
ON
OFF
07E0H
ON
ON
ON
OFF
0770H
OFF ON
ON
ON
07F0H
ON
ON
ON
ON
4
5
Factory preset: 0700H
Install the capture board on your PC again.
Turn on the power on your PC, then start
Windows.
Select "Board Setup" in "Sony DVC.^P" group.
For details, see page 15.
1 4