Sony MDS-JA20ES - Manuel (Page 5)

Hookups
Connecting the deck to an amplifier
Connect the amplifier to t h e L1NE(ANALOG) IN/OUT
jacks using the audio connecting cords (supplied),
making sure to match the color-coded cords to the
appropriate jacks on the components: itd (right) to red
and white (left) to white. Be sure to make connections
firmly to prevent hum and noise.
MD deck Amplifier
=E^: Signal flow
Connecting the deck to a digital component such as
a CD player, DAT deck, digital amplifier, or another
MD deck
Connect the component through the DIGITAL IN/
OUT connectors with two (or three) optical cables (not
supplied) and/or two coaxial digital connecting cables
(not supplied).
When using the optical cables
Take the caps off the connectors and then insert the plugs
parallelly urvtil they click into place.
Be sure not to bend or tie together the optical cables.
MD deck Digital component
You can connect the optical cable
to either OPT1 or OPT2
Signal flow
Getting Started
When using the coaxial digital connecting cable
MD deck Digital component
■=£^: Signal flow
If "Din Unlock" and "C71" appear in the display
Make sure the optical cable or the coaxial digital
connecting cable is connected properly.
Automatic conversion of digital sampling rates
during recording
A built-in sampling rate converter automatically
converts the sampling frequency of various digital
sources to the 44.1 kHz sampling rate of your MD deck.
This allows you to record sources such as 32- and
48-kHz DAT or satellite broadcasts, as well as compact
discs and other MDs.
Note
If "Din Unlock" alternates with "C71", or "Cannot Copy"
appears in the display, recording through the digital
connector is not possible. In this case, record the program
source through the LINE(ANALOG) IN jacks with the
INPUT set at ANALOG.
Connecting the AC power cord
Connect the AC power cord to a wall outlet or to the
outlet of a timer.
TEN