Sony MDS-JA20ES - Manuel (Page 11)

Basic Operations
I
When “TOC Writing" flashes in
the display
The deck is currently updntinj^the
Tiihle Of Contents (TOC). Do not
mo\ e the deck or pull out the AC
power cord. Changes to an MD
made through recording are sa\ ed
only when you update the TOC by
ejecting the MD or changing the
deck to standby by pressing the
1/0 switch.
Do not disconnect the deck from the power source immediately after
recording
If you do, recorded material may not be sa\ ed to the MD. To sa\ e the
material, after recording, press = OPEN/CLOS'E to take out the MD or
change the deck to standby by pressing 1/(0. "TOC Writing" will flash in the
display at this time.
After "TC)C Writing" stops flashing and goes out, you can pull out the AC
power cord.
To Press
Stop recording ■
Pause recording* II. Press the button again or press ► to resume
recording.
Take out the MD = OPEN/CLOSE after stopping
* Whenever you pause recording, the track number increases by one. For example, if
you paused recording while recording on track 4, the track number increases by
one and recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of
arrow, opening the slot. To allow recording, close the slot.
ia\
k
tef't'
cot'
Cor
od'
IV