Pioneer PDX-Z9 - Manuel (Page 35)

English
Français
Other settings 09
35
En
Chapter 9
Other settings
Listening to an external audio source
To listen to audio from a connected external component
on this receiver, choose its input function on the remote
control.
For more information on how to connect external
components, see
Connecting audio components on
page 9.
• When you connect a cable to the F.AUDIO IN jack,
this unit’s input automatically switches to FRONT
AUDIO IN .
1 Turn on the power of the playback component.
2 Turn on the power of the receiver.
3 Press INPUT until you have selected the source
you want to play back.
4 Start playback of the component you selected in
step 1.
Turning the display off
• Press DISP OFF.
When you turn the display off, the DISPLAY OFF
indicator lights. If you press DISP OFF once more, the
display is once again shown.
• Even when set to not display, the display is temporarily
shown when you carry out a control function.
Dimming the display
You can choose one of three brightness settings for the
front panel display.
When set to AUTO , the display is shown brightly only
when you carry out a control function.
1 Press SETUP.
2 Use / to choose ‘Dimmer’ then press ENTER.
3 Use / to adjust the brightness of the display
then press ENTER.
Changing the clock’s display mode
You can choose to display the clock in 12-hour mode or
24-hour mode.
1 Switch the receiver into standby.
2 Press SETUP.
3 Use / to choose ‘Hour Display’ then press
ENTER.
4 Use / to select ‘12H’ or ‘24H’ then press
ENTER.
Disabling colour reverse of the display
If no operations are carried out for three minutes, the
colours of the text on this unit’s display reverse. You have
the option to disable this feature.
1 Switch the receiver into standby.
2 Press SETUP.
3 Use / to choose ‘Reverse Display’ then press
ENTER.
4 Use / to select ‘Mode Off’ then press ENTER.
• To turn Display Reverse back on, choose Mode On .
Volume mode setting
You can set the sensitivity of the volume control to either
a 50-step system or an 80-step system.
1 Switch the receiver into standby.
2 Press SETUP.
3 Use / to choose ‘Volume Step’ then press
ENTER.
4 Use / to select ‘80 Step’ or ‘50 Step’ then
press ENTER.
• When the mode is changed, the volume returns to 0.
Resetting the system
Use this procedure to reset all system settings to the
factory default.
1 Switch the receiver on.
2 Press and hold FUNCTION on the top panel, and
then press and hold STANDBY/ON for three
seconds.
Power is set to standby mode.
The next time you switch on, all the system settings
should be reset.
PDX-Z9.book 35 ページ ２００８年２月２６日 火曜日 午後６時３２分