Pioneer PDX-Z9 - Manuel (Page 34)

Using the timer 08
34
En
Chapter 8
Using the timer
Setting the clock
Setting the clock allows you to use the timer. 1
1 Press TIMER/CLOCK.
The current time and date are displayed.
The first time you use the clock, you are taken to the
Timer Setup screen. Make sure that ‘Clock Adjust’ is
selected, then press
\ and skip to Step 4.
2 Press TIMER/CLOCK again.
The Timer Setup screen is displayed.
3 Use / to choose ‘Clock Adjust’ then press
ENTER.
4 Use / to set the day then press ENTER.
5 Use / to set the hour then press ENTER.
6 Use / to set the minute then press ENTER to
confirm.
• After setting the clock, press TIMER/CLOCK once to
check the current time.
Setting the wake-up timer
Use the wake-up timer to set the receiver to switch on at
any time and start playing whatever source you want.
Important
• The clock must be set to the correct time for the
wake-up timer to work properly (see Setting the clock
above).
1 Select the source you want played.
Press INPUT to switch between CD , TUNER and LINE
sources.
For example, press TUNER to select the radio as your
source.
2 Prepare the source and set the volume.
For example, tune in the radio station you want to wake
up to. Adjust the volume as necessary.
3 Press TIMER/CLOCK twice, use / to select
‘Wake-up’ then press ENTER.
4 Use / to select ‘Timer Edit’ then press ENTER.
5 Set the switch-on time.
Use / to set the hour, then press \ . Set the minute
in the same way, pressing \ when you’re done.
By pressing ENTER here, you can end the timer editing
step and advance to step 8.
6 Set the switch-off time.
Set as above, pressing \ when done.
7 Set the day(s) of the week.
Use / to choose the day(s) and / to select/
deselect it (an asterisk ( ) indicates the day will be
skipped).
8 Press ENTER until you reach the end and see OK?,
and then press ENTER to confirm.
The TIMER indicator light, and the settings are confirmed
in the display.
9 Switch the receiver into standby mode.
• You can check the timer settings in standby by
pressing TIMER /CLOCK .
Turning the wake-up timer on/off
If you have already set the wake-up timer, you can switch
it on/off by selecting
Timer Edit or Timer Off in step 4
above (press ENTER ).
Setting the sleep timer
The sleep timer switches off the receiver after a specified
time so you can fall asleep without worrying about it.
Important
• You cannot use the Sleep Timer function when a
Wake-Up Timer is on.
• Press SLEEP repeatedly to select a switch-off
time.
Choose between 5 min , 15 min , 30 min , 60 min , 90 min ,
Auto (automatically switches off after the currently
playing CD or SACD has finished
2
) or Off .
• To check how much time is left, press SLEEP (the
remaining time is displayed momentarily).
Note
1 • You’ll need to set the clock again if you unplug the unit (or in case of a power failure).
• The default setting is 12-hour format. See Changing the clock’s display mode on page 35 to change it.
2 You cannot make Sleep Auto settings during repeat playback of a SACD/CD.
PDX-Z9.book 34 ページ ２００８年２月２６日 火曜日 午後６時３２分