Thermador Masterpiece Series 24 Inch Microdrawer Microwave Use and Care Guide - Manuel (Page 11)

English 9
Before Operating
Before operating your new MicroDrawer ® microwave
oven make sure you read and understand this operation
manual completely.
• Before the MicroDrawer ® microwave oven can be used,
follow these steps:
1 Plug in the MicroDrawer ® microwave oven. ENJOY
YOUR MICRO- WAVE TOUCH CLEAR AND
TOUCH CLOCK
will appear.
2 Touch the STOP/CLEAR pad. : will appear.
3 Set clock.
TO SET THE CLOCK
1 Touch TIMER/CLOCK pad and number
2
.
2 Touch number pads for correct time of day and touch
TIMER/CLOCK pad again.
This is a 12 hour clock. If you attempt to enter an incorrect
clock time,
ERROR will appear in the display. Touch the
STOP/ CLEAR pad and re-enter the time.
• If the electrical power supply to your MicroDrawer ®
microwave oven should be interrupted, the display will
intermittently show
ENJOY YOUR MICRO- WAVE
TOUCH CLEAR AND TOUCH CLOCK
after the power
is reinstated. If this occurs during cooking, the program
will be erased. The time of day will also be erased.
Simply touch
STOP/ CLEAR pad and reset the clock for
the correct time of day.
Note:
• The MicroDrawer ® microwave oven can be programmed
with the drawer open except for START (+1 min)
TIMER
1 Touch TIMER/CLOCK pad and number 1 .
2 Enter time.
3 Touch TIMER/CLOCK pad again.
To cancel timer, touch STOP/ CLEAR .
STOP/CLEAR
Touch the STOP/ CLEAR pad to:
• Erase if you make a mistake during programming.
• Cancel timer.
• Stop the MicroDrawer
® microwave oven temporarily during
timed cooking.
• Return the time of day to the display.
• Cancel a program during cooking, touch twice for timed
cooking.
OPEN OR CLOSE MICRODRAWER ®
MICROWAVE OVEN
Always press the OPEN or CLOSE key on the control
panel to open or close the drawer.
Do not push or pull the drawer by hand, except in case of
emergency, such as during a power failure. If necessary,
push or pull slowly.
Note:
If the unit is flush mounted with no power, open the unit by
using the following procedure:
Using a needle nosed plier, grab one of the inside
columns at the bottom vent of the door (carefull not to
scratch or damage the plastic/decoration) and pull door
open. You could also use a 90 degree angled screw driver
and/or angled hex key by inserting into the middle of the
bottom door vent and catch the bottom of the plastic door
frame and carefully pull open (see below).
Use needle nose
pliers to grab plastic
vent column.
Use 90 degree angled
screw driver or an angled
hex key and insert through
vent opening to pull open.