Labconco Protector Stainless Steel Radioisotope Laboratory Fume Hoods 1208 Series - Manuel (Page 39)

Chapter 7: Modifying the Protector Radioisotope
Product Service 1-800-522-7658 35
Original instructions
Installing Ceiling Enclosures Above the
Fume Hood
Your Protector Fume Hood has mounting holes to accept a ceiling enclosure to
close off the area between the top of the hood and the ceiling. Contact Labconco
Customer Service for ordering information.
Figure 7-1
Installing Rear Panels Behind the Fume
Hood
Your Protector Fume Hood can be modified to add a rear panel behind the fume
hood when the fume hood is placed on an island (not available on Pass-Through
Fume Hood). Contact Labconco Customer Service for ordering information.
Installing Guardian™ Digital Airflow
Monitor or Guardian™ Airflow Monitor
The Guardian Airflow Monitors continuously monitor face velocity through the
fume hood opening. The fume hood right corner post is factory prepared to mount
either monitor. Contact Labconco Customer Service to order.
Sash Stop Kit – Field Installation
(P/N 9410300)
The sash stop kit restricts how far a vertical-rising sash may be opened. This small
plastic device may be easily field installed on the fixture corner post of any fume
hood.