Danby DAC150ECB1GDB - Manuel (Page 21)

INSTALLATION INSTRUCTIONS
8
Install Chassis into Cabinet and Install:
1. Lift chassis and carefully slide into cabinet, leaving 6 inches protruding.
2. DO NOT push on controls or coils.
3. Be sure the chassis is fi rmly seated towards rear of cabinet.
4. Installation of front is the reverse of removal, outlined in section 1 (“Remove Chassis”)
Safety Lock
1/2” screw
Window
Sash Seal
Fig.M
h
locking screw &
flat washer.
13/16in.(20mm) Screw & Frame Lock (2)
Fig.L
7/16in.(12mm)
CARE AND MAINTENANCE
CLEANING THE AIR FILTER
CAUTION
Before cleaning or servicing this unit, disconnect from any electrical supply outlets to prevent
possible shock or fi re hazard.
• DO NOT use gasoline, benzene, thinner, or any other chemicals to clean this unit, as these substances may cause
damage to the fi nish and deformation of plastic parts.
• Never use harsh cleaners, wax or polish on the cabinet front.
The air fi lter should be checked at least once a month to see if cleaning is
necessary. Trapped particles in the fi lter can build up and cause accumulation
of frost on the cooling coils.
•
Push the vent handle to the vent closed position.
• Open the front panel.
• Grasp the fi lter, pull up and out.
• Wash the fi lter using liquid dishwashing detergent and warm water. Rinse
fi lter thoroughly.
• Gently shake excess water from the fi lter. Be sure the fi lter is thoroughly
dry before replacing.
• You may vacuum the fi lter to clean.
Note: Never use hot water over 40°C (104°F) to clean the air fi lter.
CAUTION
Never operate this unit without the air fi lter in place, as this may
result in damage to the unit.
17