Danby DAC150ECB1GDB - Manuel (Page 19)

INSTALLATION INSTRUCTIONS
2
Install Top Angle and Side Bracket:
1. Attach foam gasket to top angle above holes as shown in Fig. F.
2. Install top angle and side retainers to cabinet as shown in Fig. F.
5/16in. (8mm)
long hex-head
Fig. F
3
Assemble Window Filler Panels (see Fig. G):
1. Place cabinet on fl oor, a bench, or table.
2. Slide the window fi ller panel frame into the top (L
shaped) and bottom (U shaped) channels. The shut-
ters are identifi ed (on the frame) as left and right.
3. Insert washer head locking screws (2) into holes in
top leg of fi ller panel frame. Do not totally tighten. Al-
low left to slide freely. Screws will be tightened later.
Plastic
Frame
“U”Shaped Channel
Window Filler Panel
“L” Shaped Mounting
Bracket
4
Install Top Angle and Side Bracket:
1. Open window and mark center of window sill.
2. Place cabinet in window with lower “U” channel of
cabinet fi rmly seated over window sill. Bring window
down temporarily behind top “L” bracket to hold
cabinet in place.
3. Shift cabinet left or right as needed to line up center
of cabinet on centre line marked on window sill.
4. Fasten cabinet to window sill with 2 screws (you
may want to pre-drill holes).
5. Add bottom rail seal over screws to window sill. See
Fig. H.
Fig. H
Bottom
Rail Seal
3/4in.(19mm) Long
Hex-head Screw
15